Recent content by 1967Fish

Looking for non fender well headers for my 440 A Body 1967 Barracuda. What choices are out there?

The reason I'm not going with aluminum heads, at least for now is $$$. If I want more HP, I can always buy a set and different cam. I've had these heads just sitting aroun for years...might as well use em. Several years ago, the heads were in a friends 68 fastback barracuda, with the exact same...

Hi fig. I've got a set of heavily ported 346 cast iron heads with 2.18 intake and 1.88 exhaust. I took a few pics last night. I'll post a pic or two soon.

Yea... I'll be curious to hear how much the build costs as well.

This thing is starting to go together quick. Maybe I missed, with all the discussion, but are you going with a solid or hydraulic cam? This project sure has changed... in a good way. :) I think your original goal of around 450hp is gonna get blown out of the water. :) EDIT: after reading a few...

Well, I hope it will be that easy to pull 500+ hp. I'll be doing lots of research in the coming months. Gonna be a fun thread. When done I'll be dynoing the motor to see what kind of HP it's making.

I'm looking to build a 512 stroker from 440 Source over the winter. I'm not sure of the exact details of the build yet, but I can tell you the goal is a 500 hp streetable engine that runs on pump gas is the goal .So this means no more than 10:1 compressio n.Probably a mid 500 lift cam. I don't...

Ok guys... thanks! I'll check Ebay. What about corner trim?

All, I would prefer plastic because from what I have read, you hav to remove the rear window with stainless. Thus, I would have to get a window gasket. Am I correct? HOWEVER, if needed, I woul get stainless. Thank to all of you for helping me thus far. :)

Looking for rear window trim for a 1967 barracuda, (notchback). PM me...