Recent content by 64Cuda360

true, but the manual has literally everything from the fifties, and runs all the way through 1966. as thick as a large phone book. but I do doubt it's accuracy in this case. any other instructions would be greatly appreciated, i would love to try every suggested hook-up until it works.

it's actually an old service manual from 1966. it has about 6 pages on this tranny alone, and 6 steps on installing the cable, and a seperate 6-8 steps on adjusting it. and yeah, the buttons can all be pushed while the car is off. including the park lever. i'll try to find another usable...

I've been using a large manual that told me how to precisely hook up the shift linkage. I hooked it up and have redone it 3 or 4 times. when i hit the drive button or 2nd or 1st button, it stays in reverse

cool, Well I know the Switch, but how would I adjust?

okay, so that could cause the tranny to get stuck in reverse

most likely, but i really don't know for sure. we got this car half built from a family member. engine and tranny professionally rebuilt, and installed, just not hooked up. We had to put all the linkage on. engine appears to have spacers and what not for the engine swap

The torqueflight 904 tranny in our 64 barracuda will only go in reverse. I've adjusted the gear shift cable at the transmission about 4 times, and it's usually barely in gear, or fully in gear when i start the car but always in reverse. the book says five notches when adjusting, and I can't...

edited in another engine shot above..

First post on this forum, so please go easy... So we've had a 1964 1/2 Barracuda in the family since new, our cousin dropped in a 360 from a 70 dart after the engine quit. it already had had one rebuild. it has the push button torqueflite tranny. the 360 is a fresh rebuild. The problem...