Recent content by 68barracuda

Im looking at a set of 5205 fenderwell headers for my 71 dart with a moderately built 518hp 440. I was wondering if anyone has pics or info on Tire clearance Issues Overall fitment in regards to the engine bay :-D Ground Clearance issues Any helpful experiences???

I installed the abody boot on my e body pistal grip BEFORE I installed the shifter handle to my shifter and no problems so far.O:) Are you guys pulling it over the big end?8-[

That looks like the 68 A body one I ended up using on my Barracuda. My thread called Z bar Woes shows the same part.

I have it all in and it seems to work well. I used the non rusty Z bar and I added 3/4" to the arm actuates the shift fork and that helped a lot. Car is very fast with the new 340 I built and the 4 Speed lets me ring out the gears more thus improving the fun factor.:burnout:

I have a shifter and rods and a Bellhousing along with a shift fork and mabe a trans cross member. I also have an b/e 4 Speed along with a A Body tail housing and gears that needs a rebuild but is a good core. Let me know if you are interested I'll let the stuff go cheap! Located in Detroit...

The wheels in these pics are centerlines telestars. the wheels on the car now are weld pro stars. this is where the centerlines are now!

It just takes a little time and a lot of work. a few more pics. interior is leather.

68 Cuda Coupe Newly built 71 340 forged and balanced internals. Ported 915 with stainless 2.02 intake, 1.60 exhaust valves new springs retainers bronze guilds. Headman coated under chassis headers, air gap intake, MSD Ignition 6AL and Pro Billet distributor. 1 wire alternator, march pulley set...

New in box, I added Power steering to my wifes small block and cant use the single groove set up. paid over 200.00 with shipping. My loss your gain. 170.00 part #10210

I have a 72-74 A body 4 speed bell-housing, can be used in 67-71 if you use the corresponding bell-housing ball stud mount. No stripped holes or damage, Had been repaired professionally. $100.00 <a...

Yup, and you asked the same questions then also. If you had read my post are are all answered in the original description. I thought I mentioned I had just completed the swap. I never asked about the shift rod ether time, it is a F Body and is the same length, Not a problem. I'm pretty sure...

Well I have 2 different Z Bar Photos. One is a remake that came with my Trans and does not look quite the same as the supposed original. The arm is longer that goes to the shift fork on the one that is suppose to be stock. and the clocking is also different. Anyone know which is which? I have a...

I have a A Body 4 speed for sale in good working condition. $1500.00

I see this is an old post, so I guess I wont bother asking the same question.

I was told to use a panhard bar on mine.