Recent content by 68sedan

Do you know if the rear seat would work in my '68 2 door sedan?

Still have this?

http://www.summitracing.com/parts/pnx-600/overview/ this is what I use on my pull truck.it was easy to install,easy to adjust and it works.

I'm not here to dump on your thread I just don't get the "slammed" look, I'm on the other side of the fence.When I look at that truck all I can see is dana 60 front 70 rear and a set of 35's(at least).So each to their own.Now with that said if you get the whole truck I'd go new hemi.OBD II and...

Yeh he did my set,great cut good work to bad I didn't take pictures,had zero issues with them so far

sounds like a chevy thread to me,you know drill a couple holes put an emblem on it and bang your camaro's an SS.

I agree with everyone else here just measure it to make sure it's an abody.Any "pig" will fit it so put it in,drive it and look around for a complete center section.It wouldn't last five minutes around here for that price.

Thanks

Not mine but I like this one,does anyone know the code or the owner?

Mohawk http://www.mohawklifts.com/wp/consumer/automotive-lifts/2-post-lifts/system1/

Not mine but take a look at this http://www.forabodiesonly.com/mopar/showthread.php?t=204769&highlight=dynomax

Built a engine for a friend of mine and he's doing some cement work for me.He came over today and surprized me with this.Pretty cool................and appropriate don't ya think.All I can say is thanks for awesome friends.

I like it,can you post tire and wheel sizes?

Correct if I'm wrong but is this the part you're asking about?

I built what you have there only differences,750 carb,4.10 gears,3500 lbs car and 2500 stall.Not enough stall FOR ME.In my opinion a 3000 would have been a much better match.If your cam is the mopar P4120231 shaft it's a [email protected](not small for a street car) and rated at 2600-6000 so why use...