69 cuda's latest activity
-
The top one visually looks correct for a factory points system circa 1967. But since you are changing ignition systems, the functional... -
The specs are hot actually they will never test proper out of the box. FSM has the testing temp usually 80 or so. Testng combos on...
-
Well back in the day, DC had the system worked out. This is from the Speed Secrets (Carrol Shelby cover) version of the engine book...
-
When you start using aftermarket coils, then you have completely changed the engineering. There is no guarantee that some other...
-
I'm adding a reproduction ecu engine harness to my 71 Demon. I'll be using the super coil. So yes the question would be which is the...
-
Is this on a car with original electronic ignition? The single ballast is for the coil, nothing to do with ignition. The dual ballast...
-
I'm going to be running the Mopar electronic ignition with an Accel super coil. I've done a bit research and the answers are all over...
-
69 cuda reacted to Kern Dog's post in the thread What ballast resistor do you use for the aftermarket electronic ignition system? with .That is simple to someone that is familiar with electronics. It isn't so simple to someone that has more experience with mechanical...
-
69 cuda reacted to halifaxhops's post in the thread What ballast resistor do you use for the aftermarket electronic ignition system? with .great explanation here FYI.....on the ORIGIONAL issue of the MOPAR ECU's system (approximately 1973 +/-) used the four pin ballast...
-
i have tried about 10 different spray bombs and nothing matches the dull finish on my '69 dart. It has a few nicks that i've learned to...
-
It says textured. Under my headlight bezel the untouched argent has a feel to it but it is not what I would call a texture. More like...
-
Krylon 1401 dull aluminum. Might have to order it. Worth it. Not always available in stores. Google Search: mopar krylon 1401 ...and...
-
Floor shift bracket is now relocated and drive line shortened. I got a 80" speedo cable to fit real nice
-
Now the transmission is out I cut the old headers off since they were junk and removed 340 cleaned and inspected bearings put rear main...
-
Here is a few of my 70 dart and the cross member and tunnel.Still need to finish the upper plate that goes in the tunnel on to the...