69conv's latest activity
-
I can't recall if I ever posted this. The way it looked a couple years ago. (car has since been sold). Intake, valve covers, and air... -
69conv replied to the thread Oil be darn.That sure sounds like it. The shop I used specializes in head work. Valves, porting blending etc. They occasionally do a complete...
-
if the second ring is installed upside down everything is fine for the first half hour then you get exactly the problem you see...
-
69conv replied to the thread Show off your small block..My small block is gonna get a little smaller. Going into the shop to figure out an oil problem.
-
-
Was New NOS Mopar Block ( X-Block) 4.040 Bore. Forged stock 340 stroke crank so 340ci Comando Heads 202/165 (53cc)
-
My 74 duster 360 stroked to 408....
-
69conv replied to the thread Oil be darn.Whether its valve seals or rings I'm not dealing with it so I'm prepping it to go to the shop. The one I use has a dyno so they can fix...
-
-
69conv replied to the thread Oil be darn.Some on top of the valves. Thinkin valve seals are part of it.
-
-
69conv replied to the thread Oil be darn.Not seeing a bunch of oil in the runners. Nicely ported tho. It was assembled when I picked it up so I haven't seen the runners before.
-
-
eagerly await the answer...
-
Had a similar problem and found a leaking intake gasket. Changed it paying particular attention to the gaps that need RTV. I chased...
-
Yikes? Ben has NEVER been that drunk!!!
-
-
69conv replied to the thread Oil be darn.Tomorrow the top comes off so we will see.
