Recent content by 69Dartconvt69

Hostile my :bootysha:. My appologies plumduster, was just trying to lend a hand and didn't want to piss all over your thread. I stayed away from this site for quite a while and I think I will get back to it. Hey mods, can you delete my account please, I'm through here.

{I don't think this is a bleeding problem. If it was you would not be able to "pump up" to a good pedal--it would still be mushy. I think either the rears are too loose (adjustment) or the master bore is a mismatch to the disc/ rear cylinder bores.} Then I will just leave the mechanicing...

Did the car do this before? Is this why you changed the cam? If not I'm going with vacuum leak on, especially since you stated it smooths out on higher rpm. Check the intake with WD40/starting fluid along both sides see if it smooths the idle. Can't imagine dist, valves or carb if it didn't...

I just use one of those but my car is in my 2,400 sq ft shop out here in CA so I really don't know if it's good in the weather.

If you have a power bleeder you can. Easiest trick is to pull them off, slide a chunk of 2x4 in and have someone pump them while you rotate the bleeder to the high side and do this several times for each one and then you'll be set. Make sure you put a little hose on the end of the bleeder unless...

I am guessing you've never bled a set of Kelseys before. Bleeding them mounted on the car is never going to get all the air out.

You guys crack me up, you got to be creative. They eat those things up for the Cub Cadet and old IH pulling tractors. I sold the chunk and axles out of one of those to a guy in Wi for $125, they shorten the axles, make a few changes to their Cub Cadet gear boxes and they drop right in. Get this...

http://www.engineshipping.com/ Used them dozens of times, just strap it on a pallet and they pick it up and door to door service or terminal shipping. I thought they had good prices for the level of service.

Off the market, I will keep it.

I've bought parts from him, most are priced decent in my opinion but I don't shop at ChinaMart so perhaps my threshold is different than those complaining. I think about the effort a person like him has gone through to locate these original parts, build a warehouse to store them, advertise...

I have a set with new joints and bushings or a set of old used ones, depends on your $ goal. PM sent.

PM sent

If your float wasn't heavy or obviously filled with gas and you stated it floats in water, you probably don't have a problem with it. Not knowing any other details I would suspect a bad ground, you probably gave it a good ground when you tested it but you need to make sure your ground strap is...

Lowering the price to $500 obo before I pull it. Thanks

I have what you need, PM sent.