AJ/FormS's latest activity

  • AJ/FormS
    AJ/FormS replied to the thread The power of a 273.
    IIRC, that is a 106wb car? 12s with a 240@.008 cam, lol, how cool is that! I have held those stock early rods in my hands, :lol:. I...
  • AJ/FormS
    AJ/FormS replied to the thread 318 cam upgrade.
    The stocker runs pretty good when advanced. IIRC they are 240/248/112 , and they fall in at around 2* advanced. One time, back in the...
  • AJ/FormS
    :lol: My 2cents; $2500, less the cost of a trans and convertor ($1700 plus Rnr) , so $500 tops. lol
  • AJ/FormS
    AJ/FormS replied to the thread Thin head gaskets?.
    I installed a pair of 028 sandwich gaskets, I do not recall whose they were. At 11/1, they blew out in less than a year. 040 FellPros...
  • AJ/FormS
    this might make you feel better. I began wearing eyeglasses at age 15, so I could get my driver's license. I wore them damn glasses to...
  • AJ/FormS
    Just so you know; In my 367/Commando 4-gear/with 3.55s, is an ancient Hughes cam; 276/286/110, 230/237@050 . Goes like a raped ape...
  • AJ/FormS
    AJ/FormS replied to the thread After market OD?.
    I built an engine with a broad-flat torque curve and a small cam. And I put an A833overdrive behind it. It was a pretty good combo, if...
  • AJ/FormS
    The timing marks are NOT the problem. A problem only exists if you do not know how to reconcile them to the TDC mark on your balancer...
  • AJ/FormS
    AJ/FormS replied to the thread Holley Confusion.
    That doesn't automatically mean that the timing is across-the-board right If it doesn't detonate at WOT, well, you got that going for...
  • AJ/FormS
    AJ/FormS replied to the thread Swapping a A833OD for a A833.
    All my m/t 69 and 70 A-body cars had the small retainer. I bought my first one in fall of 1970 with just 11,000 miles on her. The...
  • AJ/FormS
    AJ/FormS reacted to rumblefish360's post in the thread Swapping a A833OD for a A833 with
    Agree
    Agree
    .
    I have found that a 3.21/3.23 or better, a 3.55 is best for a street strip effort ratio with the low first gear. Any rear end ratio...
  • AJ/FormS
    AJ/FormS replied to the thread Swapping a A833OD for a A833.
    Well , What I know is this; in my limited experience; for the short-tail A-body transmissions; The 1x23 boxes mostly use the 307 front...
  • AJ/FormS
    AJ/FormS replied to the thread Holley Confusion.
    On my 360 I have an ancient Holley 750DP. It was old already in the mid 70s when I got it used. Yes the throttle shafts are pretty...
  • AJ/FormS
    AJ/FormS reacted to Newbomb Turk's post in the thread Holley Confusion with
    Agree
    Agree
    .
    How much play is in the throttle shafts? I’ve only seen a couple that were worn out. I’m not sure why you can’t tune it but unless the...
  • AJ/FormS
    AJ/FormS replied to the thread [WANTED] WANTED - A903.
    903s were born "sloppy" shifting. Even a fresh rebuilt one . I mean have you seen the internal design? If it ain't grinding gears, the...
Back
Top Bottom