Recent content by avf383

If I had that option downunder I’d buy a new tank every time irrespective of cost

The intake originally shown is off a hemi 6 correct, looks like the repro of the manifold they had on the vg e34 pacer which ran an avs 4934 downunder

Thank you

Can someone please tell me the thread type and size of the bypass fitting in the cylinder head to the water pump please? thanks

I asked Ken @ Oregon for the 2106r, isn’t this cam between a rv10 and 20, I just saw the cam I mentioned local and saw the lift smaller so thought it would do as an interim until I could get what was recommended

New cam and lifters was around 300usd and shipping another 175usd around 650 Aussie, but thanks for the reply

Can someone tell me about the cam specs below, I need a cam to get a car going, and would love to get an Oregon cam but don’t have the $750 Aussie dollars delivered at the moment. In the future yes but for now, will the below do for a 2bbl, bbd carter and 2 1/4 inch exhaust and 9.5 comp...

ok great and thank you for the quick reply

Is a there a small one on the inside shaft that goes inside the engine? Sorry I haven’t removed yet, just want to ensure I have everything in place so car is mobile again as quick as possible

Thanks all

After somewhere that sells the oil pump o rings, tried searching to no avail. Any leads or links please? thanks Ed

What size are the plugs on the end? And you just knocked one side in and removed like a water welsh plug?

I read it a couple times and enjoyed the knowledge sharing as I do with plenty of posts on this forum, if I can learn something new daily and apply it to my cars I’m happy. Thanks for the post.

You guys are so lucky with your engine cores, down under we are lucky to get a teen for a k, and good luck finding a 340 for less than 4K for a rebuilder.

So what’s your YouTube page anyhow?