Just when I thought I got it all figured out I have a little wire fire at the engine side of the bulk head connector. The J2 16DBL fried about 12" of wire out from the bulkhead. There was actual flames. I put it out pretty fast & I am not really sure what started it as I think it was bad...
I am just looking at the manual & see a hook at the short end of the spring that I believe a large screw driver & a pair of channel locks will release the end of the spring.
I have seen that from National Moparts up here in Canada. I maintain as long as the hole is large enough to go over the end stop it has play. The part did not start out oval. If you ever drove a car with so much play in the clutch linkage you would repair as much as you could. There is only...
My 72 Duster 4 speed had lots of play in it on the rod from the pedal to the Z bracket. The round holes were oval from 50 years of wear. I took it out & had it welded closed on both ends then used a die grinder to open up the holes again so they just slipped over the stops on the Z bracket &...
I am trying to replace the over the centre spring on my 72 Duster 340 4 speed. Has any one done this with any this that has ideas how to get the old spring out? I have washers in the new one ready to go but the one in the car I am having issues getting a screw driver in it. Thanks