I bought an 600 edelbrock from a guy that had it on a 460 ford. Im sure im going to have to change the springs, rods and jets. Any advice on where to start?
I have a 318 out of a 71 dart i put in my 1950 dodge truck. I want to give it some pep so I want to bolt on a 4 barrel carb. I have a 4 barrel intake off a 340. Casting number 2531915. Would this work with no issues for a 318? Thanks for any help.
I have the power for thj dist wired right to the ignition switch so it should have good power, I checked the date of the battery and I bought it in 2012. I think ill start with that.
I havent check the battery yet, tomorrow I will. It will turn over fine for a few seconds then slow down, then speed up, the slow and so on. Ill put the charger on over night and see what happens. Thanks again.
Hello all. I have a 318 I stuffed in a 1950 dodge truck. I'm restoring the truck myself. The motor was bought about 2 years ago from a fella on craigslist. I had the motor running last summer when I had it sitting in the frame of the truck just to make sure it ran good and it seemed to. Fast...
Very good advice from all of you, thanks very much. I'm going to check out a few think this weekend, but I think I will try an electric fuel pump, That sounds like the way to go. Thanks again.
I have a 383 auto in my 67 belvedere. I have a 750 edelbrock ,manuel choke carb and an offenhousen alum intake. This motor is a ***** to start. If it sits for a week I need to pour gas down the carb so it will fire. Even after I have it running and shut it down for a couple of hours it still...