Recent content by biggen59

OK would you check the cover, would be interested in that. Would need cut-out of spair tire bracket, and tank mount brackets + 3 Inches floor material all the way around. Other area is at the right rear inner wheelhouse, 16 inches torward center of floor and about 3 inches either side of the...

Needing a A-pillar plastic cover, 73 Swinger two door,Dark Green ,left side Part# 3674515.Also would you sell cut out sections of the trunk and spare tire well?

Since there were so few initial responses to this thread,I kinda forgot about it,and went about my business,thinking I was the only one with this issue.Unfortunatly,there is at least another member with issues as well.The strut rod issues were fairly easily resolved,with a burr grinder,heck I...

Just thought I'd do myself a favor and replace the pivots,that was a mistake on my part.As for the strut rod kit,well I can deal with a little tweaking,production tolerances being what they are,and the kit from PST is pretty nice.I guess my biggest complaint here is that when I contacted PST...

First time posting here folks.That being said,has anybody purchased the new LCA pivot shafts,and or adjustable strut rod kit from PST,and had issues with either one? Could not get the strut rod to line up,to the attaching bolt,at the LCA,(per instructions)Loosened the nut on the new pivot...

After removing my 8 3/4,to install an offset spring package,and reinstalling,it's time to put the chuck back in.The 3.55 chuck was inspected,and deemed OK for use,but being that it has been idle for several years,a new pinion seal was suggested.I believe the seal is an 8515N,but is there a...

Hi; Looking for a comlete set of front and rear windshield stainless mouldings to retro on my 67 fastback,could also use a good trunk divider,as well as the short sill plates,located on both sides of the rear seat.Return reply appreciated