Uncertain the brand of the rims.
Includes chrome shank lug nuts. 7/16 fine thread.
Fronts
- 14x6
- 3 3/8" backspacing
- 205/70r14
- 5/16" of tread.
- Tire MFG date coded 2017. however, rubber is still in good shape.
Rears
- 14x7
- 3 3/8" backspacing
- 225/70r14
- 11/32" Tread
- Some rubbing...
Kelsey Hayes SBP brake package off of a 72 Dart. Everything works as it should before pulled. Asking $700 + shipping.
Comes with everything pictured (UCA,LBJ's,Spindles, hoses, hardware, et'c) Only item not included is the lug nuts.
Rotors measure .81" thick, with plenty of life left on the...
I used butyl ribbon for a seal. placed it along the very edge of the trunk opening so there wouldn’t be much chance of water pooling between the tank flange. And floor
Added in a Catch/Oil Separator can w the Wagner adjustable PCV recently.
Also installed an AFR gauge a few months back which has been very helpful for tuning the carb (Holley 600CFM Street Warrior). Turns out she was too lean across the board. Just need to iron out the hesitation/momentary...
Taking some Inspiration from others on the forum, I went with a EFI/baffled Mustang tank & Return -style regulator with 3/8 supply and return lines.
Oh I also went ahead and mini-tubbed the Dart right before this project.
Did not like the starter relays proximity to the fuel lines so relocated...
Building my dart for ultimate goal of competing in Autocross and Road-race event
Got my Dart back in 2017 as not much more than a rolling shell, and the parts she did come with all needed to be service or replace.
After spending a summer getting her running, she spent the next few years as a...
I’ve got a ‘72 Dart that show signs that it used to have a decal/graphic on the rear end. She’s had a pretty eventful existence prior to my ownership so I don’t really expect it to be a “correct” ‘72 decal.
That being said, searching around I can’t figure out what it could’ve been. Thought...
Fuel Tank Modification
Despite my best efforts to retain the factory fuel tank mounting, the coil-over mounts crept into the tank's location just enough to necessitate either a trunk-mounted fuel cell or modifications to my OE-style tank.
I elected to modify the OE tank over the cell for a few...
4-Link is Finished!
Finished may be a bit of overstatement, as it needs a few more tweaks before I put it to the test, but it’ll hold up plenty well to some cruising. Will update further later.