Recent content by cnrtybyathrt

ok does have a linkage, it does run good i just thoughtyou would be able to see it spray gas.

it is and thank you

ok i have a mild cammed 340 in my 74 duster.airgap and 1406 eldebrock carb msd ing.question is if i look down in the carb there is 4 places for gas to come out into the carb body.the back 2 i assume is the 4 brl.. ok the front 2 lots of gas back 2 very little if any. and that would be just...

no i dont have wire dia. is it possible i just burnt out the reg.

ok what i did was jump(just touch) a wire from amp gage to the gas gage nut on pc board.the gage went to full. removed wire and noticed i lost oil light, was on with key on but not started.then i moved bulbs around it never came back on.then i jumped amp to temp gage same thing went to hot.then...

most likely i cook them, tested with 12 volts thank you i guess i'll look for new dash thank you

1974 duster is the regulator the silver box on back of dash

ok temp and gas guage dont work did before i removed dash 2 years ago can short gauges over from a hot wire they move tried to run jumper wire from gas sending unit both hot and ground still doesnt move have ran new ground to dash

just went and look it appears to be round forge crank the tranny is rebuilt the man is suppose to find out what value body ect and new 3000 stall converter

thanks fishy i do know the crank has 6 bolts i just didnt want to bye i trany and converter and not being able to use it

i believe its a 71

is this the flexplate i would needhttp://www.jegs.com/i/B%26amp%3BM/130/10239/10002/-1

thanks kim but i think i miss wrote i want to put a 360 904 on a 340 motor again sorry

can you hook a 360 904 to a 340 seams to me i read somewhere you need to knock off weights or something aftermarket converter

thanks guys