Recent content by Crusty Brian

Thanks for the reply, all 3 had the "in" stamped on the case. It ended up being the pump

Like it was pushing too much fuel and backing up at the filter. I've never experienced this from a bad pump.

Thanks everyone, No sir, I was asking if it could be the fuel mixture or the fuel pump

Thanks everyone, I replaced the fuel pump and the problem is solved!

It's leaking at the line

So my 67 dart gt fuel filter is spraying fuel out. It's a 273 with a 500cfm edelbrock carb (brand new, maybe 200 miles on it) I'm on my 3rd fuel filter in 1 day. I've removed the Top of the carb to see if it was plugged up, nothing. The tank, sending unit and lines are new, wich was evident by...

Dumb *** question time! I'm installing a new dash wire harness in my 67 Dart and I decided to replace the ignition switch since I'm in there. I got a new one from Laysons buttttt, the new one has an extra terminal for a ground. Will this cause any issues with the new harness? (New harness is...

UPDATE: Once I got the harness almost out I found the there was a wire spliced into the ignition switch connection (I'll post a picture) the wire ran thru the firewall to the ignition connection on the voltage regulator, with a smaller wire also connected to the ignition connection, but ran to...

I'm not planning on reinstalling it when I'm done, see what it does then

I did that and it acted like it should! Even dumps down a bit when cranking the engine. I hear what your saying and I'm surprised as well! But like I said I'm not done tearing the rats nest out from under the dash. Its a total **** show, bunch of after market gauges and lights

I meant 18 gauge under the dash, the jumper wire is 12 gauge. And when I was having issues with the voltage regulator (was just not getting a good ground) I check it constantly with a multi meter multiple times and was getting 14 volts on the battery and the gauge would read just a hair to the...

My bad earlier saying it was + and -, I just skipped saying red and black wire. The gauge works great I was just curious if anyone had seen this before, granted I'm not done rooting through the **** show of rewiring (all blue and looks to be 18 gauge except for the tan home stereo speaker wires...

I'm installing a new dash wire harness in my 67 Dart GT, aside from needing to solder some pins back into the circuit board, the board looks to be in great shape. Except it has a wire connecting the + and - posts on the alternator gauge(on top of the standard red and black wires). This is my...