Recent content by D.Dog

Sorry about the mis communication! My wiring harness is from a non AC 68 dart. the blower switch is is a 68 dart with wire harness. The resistor plug is different Can it be made to work? Harness is non Air 68 harness Resistor board is 2521409. Any help would be appreciated!

The plug on harness are different. Could I change resistor boards or change wiring or plug receptacles. The motor has been checked and new brushes installed! Could you give me a solution. I am well versed in soldering! Thanks!

I am using a 68 dodge dart used dash wire harness. I have a 69 heater motor but the lplug receptacles for the my motor is different. I have wiring diagham for 68. Basicly they have different plug ins to resistor board Can this be modifed to work? Your help would...

Your help would be appreciated! thanks!

Thanks for the replies! I called centerforce. They said it might take 3/8s to 1/2 in. release to push in fingers. I hope this is it. Thanks for the info!

NO! I think I will need to adjust clutch rod adjust=ment rod?

Gentlemen! 68 dart 360/833 change over from auto. Everything mew/rebuilt from Brewers with all new component z/bar fork,pedals #734 bellhousing//hurst comp new shifter. Everything bolted up right. Clutch new 10.5 23 sline disc centerforce street clutch. Clutch disc would not release when...

Any one have problems with clearance problem next to 90 degree oil filter&pass. side down pipe? These are stock 340 manifolds and are correct as I have owned 2 cars before. The rest of system w/ H pipe installed with no problems. Seems like down pipe is resting on my oil filter...

Anybody have fitment interference on pass side 68 dart 340/360/j head down pipe hitting oil filter side w/90 degree oil filter clearence? Mine is very tight looks like I might have a leak. Any info appreciated!

Red Line hub caps! I will enlighten you guys as I am a old fart. Purchased my new 1968 gts 340 auto the last of Dec. 68'. Car came with small red line caps. I will say it was a very late build. Just my 2 cents.

Thanks guys. After studing it that makes sense!

I am ready to install 360 motor & 4spd together. Was checking some clearances at tunnel area. Looks like I will have to unhook the rods from shifter to get them by cross member. Everything is new from Brewers. What is your wisdom? Photos enclosed,D dog!

Caliper Switch! I switched sides as everyone said. It looks good to go. When I started build I ordered parts for 73 up dart, big bolt pattern. I also ordered hoses for 1980 diplomat! Hoses bolt up good. I will probably put camero hoses on later. Setup should work nice with small bore...

Guys! another photo! I am reason from coments that reverse caliper so its on top then bleed? Get camero hoses from Dr. diff and should fix problem! Please comment! Your help is appreciated. D.Dog!