Recent content by dart sport

All Parts have been sold.

I have for finished my restoration of my 1974 Dart Sport that I bought new in 74. 400,000 miles on it. It is my buddy!!! So I have some extra parts that I acquired over the years for sale. 2- 833 4-speeds $400.00 ea One was in my 74 dart sport and ran fine (swapped a OD in) the...

Interested...What is the total with the strut rods to 30252?

Thanks everyone! I looked at the bell housings and the mounting areas are different. When I take the engine out I will measure the mounting area and make a new plate. I ordered a new pivot stud from Classic ind. and making a new plate shouldn't be too difficult. (everyone knows how that...

valiantpatrol, I think you are correct. In looking at the two and the bolt holes are in different positions on the O/D bell housing that I have. Will have to see when I pull the engine next week. Might have to make a new bracket. Darn!!

Thank you for your response. I looked at the trans and bellhousing pic in the article and I see that it is a 6cly bell housing that they are talking about. MY BAD.

The reason that I asked the question is I came across this when gathering info prior to my swap. Now they might be talking about 6cyl, I don't know, the article didn't specify. (For bell housing clearance reasons, the small 124 tooth flywheel must be used on both the 1964-66 bell...

I have a 74 dart sport that I bought new with a 318 and 3 speed on the floor. Many years ago I put a 4-speed in it with no problems. Now I am looking at putting in a 4-speed O/D unit in it. I have the proper 318 (O/D) bellhousing and O/D trans unit. Question is are these bellhousing the...

BTW just moved to GA from Colorado...need to update my profile.. Jim

Still interested. Sent a pm yesterday. Understand that the site has had a crash. So if you didn't get message pls contact me. Thanks Jim 74 Dart Sport

Are you looking to sell or would you trade for it? Either way where are you located so I could see it? BTW do you have the V-8 bellhousing for the OD unit? Thanks

New to the Form and I sent a quick reply, don't know if it went thru. Here goes again. I am in loveland but no place in Colorado is too far. Where are you located and does your OD unit have the short tail-shaft?

I'm in northern Colorado (loveland) but no place is too far. Is yours a short tailshaft and where are you located?

Thanks guys I appreciate the info. Now I just have to find one!! BTW I have a extra A-body 4-speed that I would like to swap for a A-body OD unit. anyone interested? I am located in Colorado.

Will my Hurst factory shifter on my 4-speed dart work on the later 4-speed OD unit?