Recent content by Dart Swinger 72

Got quite a bit done recently

Still in the region trying to get the swinger ready by spring

If I had to guess the dana60 complete is about 250-300 lbs. I carried it across my garage and installed it myself. Didn't weigh it but its right around there that's with disc calipers and stainless axles

I would go with a 60 or the 8 3/4 either one will be able to handle future mods . might cost extra now but you won't have to do it twice!

Whoops put that out of there twice ,my bad

Ya trailbeast I guess that was a bit of an understatement, but I do have a friend who is a distributor for Strange so I got it for less than retail

Ya trailbeast I guess that was an understatement, but I have a friend who is a distributor for strange so I did get it for a little less than retail.

I just put a strange 60 in my dart full bolt in 4 piston calipers slotted rotors 35 spline axles a little costly but worth every penny. There is also a picture of the 7 1/4 I took out of the car if yours looks like that you've got a 7 1/4

Hope the best prayers being said

Region rat!!!!

I'm in Valparaiso. Wtfneon you 374?

I know this is off subject I just see that you guys are online right now . I just got engine & tranny installed ,I can't shift out of or into park while engine is running. If I start it in neutral I have all gears .shut the car off goes right into park .? B&M star shifter, is it just out of...

Just got my new aluminum driveshaft today ! First ride!!!! Fu@# ing AWESOME!!! NOW I need to find a grill ,twilights, and headlights go for an actual cruise get break in on the tranny and rear end over with and see what it's got

Wish I would have seen that before the headache I put myself through!

Just looked your in WA probably won't be much help to you