Dave999's latest activity
-
Dave999 replied to the thread Lean idle. Rich cruise..Modern gauges should all read the same to within a tolerance that is small. A modern wideband sensor comes paired with a calibration... -
Dave999 replied to the thread Lean idle. Rich cruise..Id be tuning to somewhere 12.5 - 13.5 at WOT closer to 14 at cruise looking for 14 , 14.1 14.2 if i lift off the throttle, and...
-
Dave999 replied to the thread Balancer slides in on install.the fitment method will take into account the harmonic frequencies that are being damped,across the rpm range between idle and redline...
-
Dave999 replied to the thread Balancer slides in on install.Id find a good second hand one, just to check. if it fits tight, you know its not your crank and you can then make your decision on...
-
Dave999 replied to the thread Low speed torque and driveability ?.Ive dipped in an out through out of the thread i aint read it all sorry... torque, measurable physical unit diveability emotive...
-
Dave999 replied to the thread Exhaust manifold gaskets.a quick check, and remflex gaskets are pre cut perforated steel shim graphite gaskets.. Perfect.... for head to header if you just...
-
Dave999 replied to the thread Exhaust manifold gaskets.i have used expanded graphite on a perforated steel shim 1.5 or 2mm thick they use it for the "super heated steam" pipes in power...
-
Dave999 replied to the thread Weber DGV float setting.yes i think you are on the right track id guess redline US and Hardimans Redline Australia are working from the latest detail...
-
Dave999 replied to the thread Weber DGV float setting.@Bewy it doesn't, but seems like a potential source for the wrong float, and is also a favorite for jeep 4.2 so might be...
-
Dave999 replied to the thread Weber DGV float setting.The other method you can use But i will caveat this with its a method i use on DCOEs and IDFs not DGV. I didn't know if it would...
-
Dave999 replied to the thread Weber DGV float setting.@pishta can fully understand your frustration weber made them brass floats LCN spain owned the brand and made them brass and plastic...
-
Dave999 replied to the thread Weber DGV float setting.Ah, just realised I can't see some of the photos when i look at this at work. just looked on phone and now can. i'll come back and...
-
-
Dave999 replied to the thread HEI conversion benefits.yes if you can find one they come in at a mid price but as with rubber products NOS is not necessarily best the first versions from...
-
Dave999 replied to the thread HEI conversion benefits.Cant fault that there are better versions But MSD #83647 takes you out of the realm of general fit it and forget modules that's a...
-
Dave999 replied to the thread HEI conversion benefits.Yes id buy a mid price one where the manufacturer is happy to put their name on the box or preferably on the module wells neidorff...
