Recent content by DEREK HESER

Okay. Sounds simple enough. I've read that Schumacher makes the motor mounts for this swap. Thanks again

Also, Can I use my existing 904 and just change the bellhousing?

Okay. This sounds like an easy project (until it's not). I just wanted to make sure the '87 v8 wasn't a problem child. Not sure if it's out of a car or truck but can probably find out via engine numbers. Going by the photos from the seller, it's just about a complete engine, Including exhaust...

Hello y'all. I've got a question. I have a 1974 Plymouth scamp with a 225 slant 6. I want to drop a 1987 Dodge 318 into it. Also, the tyranny is a 904. How easy will this bolt up and what bolt up mods do I need? Thanks

Thanks!

Hey y’all, need a bit of knowledge. I have a 74 Scamp 2 door hardtop. I’m looking to see if a package tray from a Dart will fit.

Ok. Thanks brother. I'll try the parts store first.

Okay. In the pic you posted, the piece I need is on the far right. Question, each end of that line is different size. So the line I buy at the parts store has the same ends as the original or do I need fitting adapters or something?

Hello y'all. I need a bit of help with finding a certain brake line. I have a 74 Scamp with 10' front drums. I need the brake line that connects to the short rubber line on one end (at the frame) and runs under the chassis to (what I believe is the proportioning valve). The line is...

Thanks Johhny, I'll call him Monday morning

I looked there as well, didn't see just that piece, only the whole kit. Also, isn't that kit in the link for disc brakes up front?

I have a 1974 Plymouth Scamp (so the fender badge says) with a 3.7L and front and rear drums. I've been able to find the piece that connects from the hose to the back of the brake housing and I have found the hose. What I still need is the piece that runs from the hose to the (proportioning)...

Thanks for the reply cudamark. So what I have is a 1974 Plymouth Scamp with a 3.7L /6 and I want to put a 5.2L 318 Magnum out of a 1997 Dodge Ram 1500. I've been doing some research, but I'm still far from understanding everything I'll need to do the swap. I want to remove the EFI and run carb...

Hello all, I am new to the forum, I'm trying to find out information on what I need to do to switch out the Ignition from my 1974 Scamp /6-225 to a 1997 magnum 318 out of a 1997 Dodge Ram 1500. Thanks