Recent content by Dne007

My little story on the lower control arm bushings, pretty much speaks for itself;) For me, I was lucky the bushings were all but gone, I didn't know it months ago. Now I just need some torsion bars;) dne'

Thanks Glen, actually I just ordered it a couple days ago off of an ebay seller, total price like a 150 bucks;) omg, there's a lot to do~ dne';)

got the new patch panel fitted and tacked into place~ ;)

Just a little bit at a time, then one day I'll be finished;)

Hi, a little update is always nice;) I got the body/tub in primer with a couple coats of high build, then pulled out the rest of the body bolt ons, re-epoxied the support for the decklid. Also bought a slant 6 engine lift plate off of ebay~ excited to make some progress! ;)

I found another link~ out of a D100 dodge truck/ https://www.ebay.com/p/26016865767

Change of plans~ traded the 318/904 for the slant 6 out of a '75 Duster. The slant sounds intriguing and I'd like to make it look nice;) The fella took it out of his duster, drove 6 hours and we swapped. Really nice guy;) Had some scrap steel and made a little cart to move it around.

Hi, I bought this transmission mainly for the bell housing to put my slant 6 on my engine run stand. the transmission was in a mid-late 80's dodge truck(maybe) originally was on the column shift but converted to a floor shift. So, I say, well, could I use it just for conversation? It's very...

Here I have my 318 running (it is a used engine, 150psi on each cylinder, oil pressure 50-60) on my engine run stand, runs good, a few days later I installed the valve covers having had to wait for gaskets. I ran it hard, did good. I do need to install a rear main seal, this is a time I was...

Hi, I bought a factory console for my 63 Dart, I was going to go manual trans, but changed my mind. I already have an A-904. I saw somewhere where a Promatic shifter will work with this console...

Loaded the tub/body, ready for blasting. After the cold spell I can get this over to em. Blaster is less than a mile from our home. Spoke with Glen for a while today, regarding A 833s and other things, now I'm having second thoughts and just going with the 904 that I have, and a nice factory...

lol, I have a full service shop~ spared no expense! ;)

I know it's not much, but I did put my rear backing plates together. Now they're wrapped neatly and on a shelf;) dne'

Our Christmas picture;) Merry Christmas;) dne'

Thank you Glen~ yes, I'd be very interested in the firewall, like Glen said.