There is a philips screw that pinches the pivot pin to provide resistance to the window so it stays where you adjust it. You can see it in the above picture of the assembled vent assembly. You may be able to loosen this screw and pull up on the vent window glass.
Are gas pump un-leaded fuel nozzles a smaller diameter than leaded nozzles? Maybe this is the problem since we all have to use un-leaded fuel nozzles on our cars.
A 1965 Formula S would have a tach on the left side of the dash. Also the rear valance would have a rectangular cut out for the Commando exhaust resonator tip. Front sway bar too. Spare tire cover would have a "C" cut into it to accomidate the larger Formula S spare tire.
I have a 1965...
Here's a couple more pictures. I went from 13" to 15" wheels after doing a disc brake conversion. It's hard to tell from the side view picture, but the car does sit slightly higher in the rear. I really like the look of BobsDart. Torque Thrusts look awesome on that car.
Don
I think the early Barracuda's in pink had a paint code of 99 on the fender tag indicating a special order color. I've seen a couple pop up on ebay.
Don
I think the early Barracuda's in pink had a paint code of 99 on the fender tag indicating a special order color. I've seen a couple pop up on ebay.
Don
The V emblem was used on 1964 and 1965 Barracuda's, The fish emblem was used on 1966 Barracuda's as a general rule. I've heard there were some late production 1965's that had the fish emblem, though I haven't seen any myself. The only Canadian Barracuda I've seen had the word "Valiant" across...
To check if a Mopar wheel is 4" bolt pattern, measure from the outside diameter of one hole to the center of the hole opposite. Here's a measurement from a SBP rallye wheel.
Don