Recent content by Drag340

Putting my old 340 bracket motor together for a friend and found one rod out of spec. Anyone have a spare lying around? Happy to pay reasonable plus freight. Thanks!

Still have an a body clutch pedal setup? Need one for a 69 Dart.

2b364584

More detail on the 72

Actually, the 72 is on the right, I just stuck the dragster parts on it for fun.

The 72

The 70 is a white 4 door sedan, ran, had a brake leak. Slant six auto, factory air. I never drove it as it was bought for parts. Please PM an email address for photos.

I have a pretty solid 72 Swinger body and a '70 4 door 6 cylinder. Both have titles. I was going to put the '70 nose on the '72. Photos available on request. Asking $1200 for the 72, $600 for the 70. $1500 for both. Local pickup in St. Petersburg, Florida. Other parts available, see in...

I have a narrowed dana 60 that I removed from an old street racer. It has Moser small bolt pattern axles and an open 4:10 gear. I believe they used 7 1/4 ends!!! on the dana truck housing (no snubber) so it's a sloppy job but I think it would be fine for a street car. Asking $500. Local pick-up...

I have decided to terminate my 340 Swinger project, so I will be selling all accumulated parts. They need freshened up, this one is from my digger 1970 340 long block .030 over trw forged 10.5 318 truck crank 2.02 J heads pocket ported 273 adjustable rockers new oil pump I think it...

Just wondering, what wire did you knock loose?

Godspeed

Back in the late '90s I helped restore and run the Dueler 2 twin engine AA fuel dragster. We were up in the tower at Bradenton when Bob Motz made a run in his jet Kenworth. The big picture windows were flexing when he did the burner pops! Needless to say, nobody stood too close. Dig those jets...

Found some good pix here. Mike