Recent content by duster4291

oops

terre haute is in indiana about 75 miles directly west of indianapolis onn I-70. I will take 100 for engine and tranny. tranny shifts like new.

terre haute is in indiana about 75 miles directly west of indianapolis onn I-70. I will take 100 for engine and tranny. tranny shifts like new.

I have 73 duster original six cylinder. Now has a 77 360 motor bone stock. I just put new exhaust from manifolds back on it 2 1/4 inch. It has the imitation flowmasters. Car has the schumacher motor mounts and new edelbrock 600 cfm carb manual choke. Car also has a new water pump and lokar...

bearings look nice and frsh to me. i would just plastigauge and lube it well . dont tear apart

bearings look nice and frsh to me. i would just plastigauge and lube it well

pretty sure there highway gears like 2.91

not to highjack this thread but can someone help me with a cam question

its just the center section

well the x heads had the bigger valves but still were open chamber design so compression with stock pistons is still around 9 to 1 probably

i have a low compression 360 that i just put in my 73 duster. the motor is a 77 model year and im sure compression is around 8.4 to 1. i have stock exhaust manifolds and dual exhaust. i also have the stock four barrel intake and a new edelbrock 600 cfm carb. what would be a good cam for it...

i have a 73 duster with a 198 slant six will they interchange

sorry im sure its probably not since it has a 2 barrel carb. i would take 150.00

it has manifolds and carb but im sure carb is trash. motor has been siiting in garage for about 3 years. no trans just make me a offer. i may take some small block parts like a 360 aluminum intake and some nice valve covers or...

hey guys not sure what it is out of just know its for an a body and its the housing only nothing else. i may trade for a nice aluminum intake or valve covers ... not sure how much i want for because shipping will be exspensive im sure. so i was taking offers