Recent content by dustUoff

Well I've got the chance to pick up a Dana 60 with 4.10's and a posi unit that came out of an early 1970's dodge pickup. The guy said the measurement was 56 3/4 inches from backing plate to backing plate. My question is, for $250 bucks, is it worth picking this unit up? How much modifying am...

Could you check shipping for the K member to 98926? Thanks.

Hey ill take it for 50 shipped... pm me your info. To send a cashiers check

Would you do $150 shipped to 98926?

Looking for a quote from Dallas Texas to Ellensburg Washington. I'd need it in about 2 and a half weeks. Picked up around December 8th. Any takers??

Hello- Was wondering if anyone had recommendations on a vehicle transport company? I need to ship my duster from Dallas, TX to Washington State. I just don't want to get ripped off and would appreciate any recommendations on good companies you've used... or ones NOT to use too! Thanks

How much would you want for just the Adapter piece?

Dang! Wish you were closer! You wouldn't want to just sell the turbo set up would you??

Hey drtybttr I PM'd you back. Yes I still have them. They have the oil rings on them but don't come with the top two rings. Thanks

Thanks Kuda, ya they are std. bore for a 360.

top

Hey UOP, don't waste your time on people that obviously have no idea what they're talking about!! Hey by the way thanks again for letting me borrow that lift, I've got the engine back in and running like a champ!

Ok, so I just got a chance to take a look at everything and sure enough my flex plate bolts sheared off! Why the heck would that happen? I think the plate could have been bent a little, would that do it?

I have a set of standard bore Keith Black 190 pistons for sale. These pistons are basically brand new, I used them to mock up an engine so they have a few marks but they've never been in an engine that was fired. These are high compression pistons with a .050 dome top with valve reliefs. Comes...

Hey guys. So this is a start up of my newly rebuilt 360. New Cam, pistons, intake, etc. etc. This is a few days after cam break in was completed. Had no problems before. You'll notice some noise right about when I get up close to the engine with the camera. Does anyone have any idea where...