Recent content by Dwayne Fairchild

Fan shroud located!! Thanks Cudamark!!

I believe I’m looking for a two piece fan shroud. I have a 22” radiator #2582931… 2524306 upper 2524313 lower

Looking for a fan shroud for 1966 Barracuda V8 with 22” radiator. I know it’s the holy grail but I’m hoping someone has one so I don’t have to mess with trying to make an aftermarket shroud “work”… Appreciate it!

Removed Flex fan; added black 17” blank metal… i was thinking of the 19” but concerned with fan shroud fitment, once i find one.. thoughts?

Update… *Replaced flex fan with 17” 6 blade steel fan. Cooling much better. In town driving, close to 200. Highway 180-190. No overflow issue. Still looking for a 66 Barracuda shroud. Measurements of an aftermarket shroud won’t work.. maybe pre-fab in my future… Electrical Drain *found a...

And 67Dart273. Thanks

Thank you Trapster! I’ll check the timing info and let you know what it was set at..

Afternoon FABO family, Let me know by saying, I’m a novice with some previous automotive knowledge.. I’ve pulled and replaced an engine 40yrs ago and thought sure, I can do that again… So today, I have a 66 Barracuda that had the 273 2bbl & 904 tranny. I pulled it and replaced it with rebuilt...

Recently pulled from 66 Barracuda..273 V8 & 904 transmission. It starts and runs. It includes: starter, alternator, pulleys, motor mounts, air cleaner, distributor/wires and many other misc brackets. If you PM me, I can send videos of it running/driving. Located at 54956. ***Local pick-up...

This is a used Mopar Viscous Clutch Fan was purchased for my project and I’ve decided to go a different direction with this project. Looking to re-coup my investment. $200 OBO (PayPal, check or money order only). I’ll cover shipping within the US.

I appreciate the suggestions. Thanks Dwayne

I’m running the newer water pump with the passenger inlet. I had the original radiator re-cored to handle the extra horsepower. The old 66 273 had the fan blade attached to the water pump pulley with 2” spacer. The bolt pattern of the clutch is off about 3/8” from the water pump pulley. The...

Looking to my ABody Friends for a little help, I’m rebuilding a 1976 360LA engine to put in my 66 Barracuda. I found an era correct Mopar Viscous 5 blade offset clutch fan that I would like to use on this engine. I’m having a problem finding a replacement clutch where the shaft of the clutch...

Appreciate all of the information and I’ll clean it all up and make sure the oil level is right. Thanks for the help!!