RMS front end. Gen 2 Hemi. 727 trans. Does anyone know the the downangle of the transmission tailshaft? I think it's between 2-3 degrees? RMS should be same height as factory K member.
1. Custom radiator. A body to BBM. Kept 800 hp motor cool. Low miles. $275.
2. Indy 426-1 Hemi Legend valves. Intakes and exhausts. Less than 100 easy street miles on them. $140
3. Morel Hi-RPM hydraulic roller lifters. The best out there. Approx. 10 min. idle time. Perfect...
I have a Rick's Hot Rod Shop stainless tank for an A body. It was used in a 1969 Barracuda and fits fine. It is approx. 15 gallons? It has an access plate on the top and also has a fuel sender and stainless AN outlet. I believe it has a return as well. It was set up for an Aeromotive A1000...
Bought a set of 3" tailpipes and dynomax welded mufflers that I never used. Bought as kit. TTI. New. I wanna say that the tailpipes are 200 new and each muffler is around 85. I'll take $275 for all. 48124 area code.
For 67-69 barracuda but will probably fit others.
Just a couple things here.
1. Can the door handles and locks be installed prior to linkage hookup? Or do you need them half in to allow for "wiggle room".
2. Is the rod that runs to the door lock supposed to be straight as it approaches the lock or bent slightly (mine might have been...
I have the original tail light housings/lenses/etc. Also, a very nice steel hood. Original flip gas cap. I'd like to see someone use them. Shoot me an offer. Nothing reasonable refused. Location SE Michigan.
Hello everyone,
I'm new to the forum and have done some searching in the forum for my answer. I have a '69 Barracuda and I can't figure the damn turn signals out. The emergency flasher works but the R indicator light-green (on dash) does not (probably bulb). Brake lights work. I have a...