Recent content by ernie flores

Thanks I'm new to this.

Thanks I'll try it .

Thanks for the help

What's a good cam for a 71 340 with a eldebrock air gap intake and 650 edelbrock carb. 8 3/4 rearend and 727 automatic stock exhaust limited budget just for street.

thanks I'll try that when I get a chance went to Mopar show in San Antonio Tx. We had a good turn out sold some parts but am tired out Thanks Mopar friends.

Thanks for the response when I place the new o-ring on the tube I slide the filler tube into the trans and in only seems to going about and eighth of an inch passed the o-ring and then the bolt ear lines up with the transmission and engine. If I slide it in further then the ear doesn't line up...

Does anybody have a transmission dipstick and filler tube for a small block 727 with a 340 every filler tube I get is to short and leaks My trans is a newer 80's small block tranny is this the reason why?

I only need the drivers side pivot mine is stuck. for a 1968 fastback barracuda. I am older and don't understand how to use pay pal but if you send me a private message with your address I can send you a money order asap. we just put a 340 in it and can get it inspected to drive it.

do you have any more wiper set ups I need one for a 1968 plymouth barracuda?

Do the wiper pivots move freely If they do I want them But I dont know how to do pay pal but if you send me your address I will send you a money order

Where on line can I find this manual?

I recently rebuilt the front suspension on my 1968 a body barracuda fastback but my alignment guy says something is wrong because my torsion bar is rubbing on the tie rod. First he said it was my center link was put on backwards is it possible? Now he says he can't get it to align right that it...

thanks for the advice I ended starting up the engine then drove it to the Muffler shop sounds prettiiiy flow masters. I rebuilt it myself haven't rebuilt In a while but anybody have a filler tube and dipstick for this tranny I couldn't find a good straight one and this one leaks or it wouldn't...

I will check tomorrow and see what bearings were used because I didn't buy the moser green bearings and it is a sure grip. Thanks mopar friends.

I bought some moser axles shafts and when installed one has 1/2 inch play and the other 1/8 inch is this normal or is my mechanic screwing something up