Recent content by Glin

Removed ballast resistor and connected wires Still won’t start unless I jump coil to battery

It’s a ready to run system, but I going to get a MSD distributor and swap it. I have a MSD 2 coil and once I get it running, I’m going to install a MSD efi carb

I hear you brother, problem is my knowledge of electronics is very limited and I’d hate to give info on something I don’t know anything about. If I eliminate the ballast resistor,connect the ends and it still doesn’t work, what else could be the problem Thx

Yes it runs once jump is taken off Need to turn it off at ignition

Found out I don’t need a ballast resistor since I have an efi distributor (no points) Another friend told me to join wires from ballast resistor, is that right?

Thx I’ll check it tomorrow and let you know

Duster will not start unless i jump coil to battery