Recent content by gregn96cuda

  1. gregn96cuda

    [WANTED] 1970 PLYMOUTH ROADRUNNER OR SATELLITE TRUNK LID

    I have a rust free trunk lid in California. It came from a little old lady 4 door 20 years ago, gold color.
  2. gregn96cuda

    small 360 badges

    lots of c bodies had them ‘71 and up. Try over on their site.
  3. gregn96cuda

    i have curious yellow Duster 340, 4 speed 1971 project for sale near Berkeley. Greg...

    i have curious yellow Duster 340, 4 speed 1971 project for sale near Berkeley. Greg 510-367-1250 text is best.
  4. gregn96cuda

    Can you call Andy with your axle info, he’s doing the work on the neighbors car. 415-388-1981

    Can you call Andy with your axle info, he’s doing the work on the neighbors car. 415-388-1981
  5. gregn96cuda

    [WANTED] Small bolt axle shaft and drum for '65 Dart.

    She has a 1965 Dart, needs drivers side axle shaft. Thanks for the info guys.
  6. gregn96cuda

    [WANTED] Small bolt axle shaft and drum for '65 Dart.

    An elderly neighbor needs a 7 1/4" axle for her car. Does anyone in the SF bay area have a parts axle from an 8 3/4 swap, or from a broken ring and pinion? I can drive local to pick up the whole rear assembly, or just the drum, and axle shaft. I think up to 1972 should work, its the...
  7. gregn96cuda

    K&W block seal

    i used it on a '64 fury 361 that had an 8" freeze crack in the side of the block. it worked, but you have to make sure there's no anti freeze left in the cooling system. Flush the block out really good after it has run.
  8. gregn96cuda

    1970 340 block 0B325270

    I just thought I would put this out there. Found this 30 over 340 block at a swap meet in Sacramento Ca. FW340P31880245
  9. gregn96cuda

    Those plugs are not worth much, the same plugs are on the rear cover of all 71/4" rear axles...

    Those plugs are not worth much, the same plugs are on the rear cover of all 71/4" rear axles for filling the rear axle. They are worth about $3 each at most.
  10. gregn96cuda

    What's a 331 hemi worth?

    I picked up a 392 last year, so in looking around on older Hemi sites, I found out some interesting things . There are lots of adapters out now, for the extended bell housing blocks. So most can be used in hot rods. Any Hemi will look good in an old open hood car, I don't know what it's worth...
  11. gregn96cuda

    [WANTED] A good running slant 6 in Northern California.

    She has a slant that broke a piston, i was hoping someone out there has one sitting in the corner of the garage after swapping a V8 into their project.
  12. gregn96cuda

    [WANTED] A good running slant 6 in Northern California.

    An older retired neighbor has a 60s dart that she has had for many years. Recently her engine lost a cylinder and it runs really rough. If anyone has done a V8 swap nearby and has a good running slant taking up space that they could sell to her for an inexpensive price please let me know. I...
  13. gregn96cuda

    [WANTED] 1975 dart swinger special tail lights

    I have an NOS left taillight lens. I got it in a tattered box. It has one chip on the flange where it mounts, can't be seen when installed. $80 + shipping from 94804.
  14. gregn96cuda

    Live in California, my car hasn't been registered since '04, no non op?

    From my experience I would say Stay away from the DMV office. I bought a '78 Ford F-250 4x4 just because it had a 4 speed and both front & rear Dana 60s. I asked the DMV clerk to check the status. She told me that I owed back fees to 1994, and that total was $1710. I asked if these old vehicles...
Back
Top