Recent content by Hemidale426

KBs now made by UEM I think they come out to stock specs. Thanks

Hi its a 1970 340 just stock as its going to be a street engine. Thanks

looking to buy .020 replacement. pistons looked at KB243-20 any other good choices?

Thanks I'll check them out too. Thanks

OK Thanks I will check it out,

looking for a new replacement fuel tank for a 1970 duster 340 no vent tubes, any one know of a good quality tank ? Thanks Dale

OK Thanks I will more than likely go with that. Thanks again.

What is a good replacement master cylinder for a 1970 duster 340 disc/drums non power? Heard Raybestos MC36406

Thanks I was guessing about 1 1/2 inch but thats what I wanted to know. Thanks a lot Dale

what is the offset of the pinion from the center point of rear end ?

Hi just wanted to let you guys know that finally found location for light its on the back of heater control panel. had to feel to find mounting spot. Hope to never have to change bulb ! A REAL PAIN IN THE A** Thanks Everyone

Manual wire diagram says A/C or heater switch. thanks

Hi again just checked wire diagram in manual says A/C or heater switch. Thanks