Recent content by Hilton

How much could I get away with on mini tub before it got into affecting the interior seat etc. ?

Great advice guys, I always can't wait to get your input, it keeps me on the straight and narrow Hilton

That's what I would think would be the cleanest and complete option but not sure I can bring myself to go that far, I'll consider it, Thanks Batman, I respect your choice.

That makes perfectly good sense as to what I am seeing. I was wondering why I see gray primer with original red overspray on both the bottom and the inside. Couldn't figure how that got there in those layers, now I know. Thank you for the explanation on the undercoat to, also makes sense on the...

Went down to the shop today to clean up a bit and sat down to ponder addressing the underside of my 71 Demon (currently stripped down and on the rotisserie with the underside facing me). The car was originally a red and has been repainted at some time in it's life. She is going back yellow as my...

Ok, have 8.25 27 spline axles in hand and planning a trip to the boneyard for parts to perform the Cherokee disc brake upgrade. Any particular models in the 80-90s while I am there to maybe locate an 8.25 posi 27 spline? suggestions?

Okay, asking for help here on this rear. I have posted for used 8.25 27 spline axles, already have the housing, will buy new sure-grip, gear, and replace all the bearings. Cannot find any new, rebuilt, or used 8.25 27 spline axles. Soooo, since 29 spline are available, could I go with the 29...

Do you have this same information for the 8.25 or are they the same for the 8 3/4? I'm trying to locate some used 27 spline 8.25 axles and would like to know the axle that may cross.

People have asked for pictures and I only have one polaroid of the front view of the hood that I might be able to find. pictures of the one I have to start with now is as all start out in complete disassembly form to see what I need to do and my best to do it right so that won't be interesting...

My shafts are pitted on the bearing surface and would like to put in replacements from someone who has spares laying around.

Have purchased and stripped a 72 Demon, body on the rotisserie, 360 engine to build, and will be swapping out the 7.25 rear for a 8.25 ( have the housing). It will be a work of love or hate sometimes but will need your help I am sure. Right now could use some 8.25 axles to start as the donor...

I looked at those but I'm afraid the 8.25 axles are too bad. Looks like this one sat with no oil and plenty of moisture. There is not enough shaft surface left that is acceptable for the bearing and seal to run on to move the position anywhere. What makes them incompatible, is it size ...

I have a donor 8.25 rear that I will use to replace my 7.25. Problem is the donor 8.25 rear axles are pitted very badly on the bearing roller surface and will need replacing. Question: are the 7.25 axle shafts compatible with the 8.25 rear. I don't see any visual, they are both 27 spline if I...