Illahe's latest activity

  • I
    Illahe replied to the thread Crank , no start question.
    With a brass feeler gauge?
  • I
    Illahe reacted to ValiantRacing's post in the thread Speedmaster vs trick flow with
    Like
    Like
    .
    I go 10.20s with a tuned up set of Speedmasters.
  • I
    Illahe replied to the thread Speedmaster vs trick flow.
    I ran the Speedmasters with 405cp's and the camshaft attached with good results. A pair of Promaxx 171 cc heads, less valve springs...
  • I
    Illahe replied to the thread Crank , no start question.
    Made my eyes hurt…
  • I
    Illahe replied to the thread Crank , no start question.
    "The engine is on tdc #6 with the cam installed to the aligning marks on a fresh build, with your dampener at TDC."
  • I
    Illahe reacted to Dana67Dart's post in the thread Crank , no start question with
    Agree
    Agree
    .
    The ignition switch has 3 terminals to start and run the engine. IGN 1 IGN 2 S IGN 1 provides power to the coil and ignition box with...
  • I
    Illahe replied to the thread Crank , no start question.
    The engine is at tdc on #6 with the cam installed to aligning marks on a fresh build with your dampener at TDC.
  • I
    Illahe replied to the thread Crank , no start question.
    I Always have a point distributor lying around for this reason. The aftermarket boxes and or old boxes can give you fits. Look up the...
  • I
    Illahe reacted to 92b's post in the thread Timing with
    Thanks!
    Thanks!
    .
    Thanks for sharing your process. Sorry for sounding like a broken record but If there was a reason why sweep testing doesn't work I...
  • I
    Illahe reacted to Newbomb Turk's post in the thread Timing with
    Like
    Like
    .
    Sadly, you ain’t wrong. Hopefully next week I can get my garbage on the pump. Then I will see if I can do 12:1 on pump gas AND use...
  • I
    Illahe replied to the thread Timing.
    Being in the poorhouse I bought an MSD (distributor) copy and pulled it down, then welded the advance plate to locked. Phasing became...
  • I
    Illahe reacted to Newbomb Turk's post in the thread Timing with
    Thanks!
    Thanks!
    .
    I wish that were true, but my testing says it’s not so. I want to start with finding a curve with MBT (MINIMUM timing for Best Torque)...
  • I
    Illahe replied to the thread Timing.
    Go MSD Grid. I'm still learning mine, but the more of this thread that I read, the more the products abelites come into play.
  • I
    Illahe replied to the thread Timing.
    This makes the most sense to me: "If I know what the timing is and the power at each rpm Increment I can chose the timing amount that...
  • I
    Illahe reacted to 92b's post in the thread Timing with
    Thanks!
    Thanks!
    .
    It's not just one. That's just the one I sent you that I had the documentation handy. I not saying that some race engines couldn't...
Show older items
Back
Top Bottom