Recent content by Indy

I used the same diagram when hooking it up and the guy helping me did put a special grease on it. It does not quit running it just misses when cruising. I have another coil but first I will reconnect the ballast. Thanks guys I will let you know.

I put a 1975 318 in my 1968 dart it has electronic distributor added the hei on firewall. By passed the white resister it runs but cuts out when the engines gets to temp when cruising. Will idle can get into it it will run good any suggestions please help if you can.

I just want to thank you guys for any information that you gave me. I’m glad we have this site to help each other out Happy 4th of July

I finally got my motor back together and in my car. I used the slant k member that was in the 68 the one in the V8 car was to rough.Bought the motor mounts they worked great I see why I had to cut the hole in the floor I will be posting pictures the only ones I could find didn’t show how the...

I saw that video it will be helpful thanks for all the feedback.

New to the Mopar way finally collected all the 4 speed stuff to do the swap was not sure about the tunnel Thanks again

Ok thanks for info

Ok thanks I have not started putting it back together yet I just saw some pictures and was wondering.

So its the linkage rods and possible the shift levers that mount them to the trans that need clearance.

Can anyone please tell me do you need to cut a hold and install a tunnel to swap a automatic trans for a 4 speed? Thanks

Can anybody please tell me if you can go from an automatic trans to a 4 speed without cutting a big hole and putting a tunnel in? It looks like there may be enough room. Thanks