Thanks! If you plan on factory air conditioning I don’t think the factory air cleaner will fit, but probably easy to mod. Besides, I’d go with a modern compressor anyway…..
That looks like enough dimensions, let me see what I can draw up. Now that I see the picture I believe it can be printed with the rounded top. I'll post a picture of the drawing first, might take a day or so to get time to do it. Once it looks good then I can print a few samples.
Thanks!
This one? I could do that one, because of the way it must be printed the top surface would be flat rather than rounded. If you were looking for originality it wouldn’t look quite right, but it might be close.
For 3D printing, one side must be on the printer bed. So that side will be flat...
I left the rubber gasket on for 1 week since the fuel level was lower than the gasket. When I took it off to put on the TPU gasket the rubber had already started to crack. That was a brand new rubber gasket, glad I got rid that one.
Thanks to all of you for all the tricks on making the repo...
So far, full tank and no leaks so that TPU gasket is working fine. I really liked the way it compressed without pinching- the rubber gaskets tend to drag with the lock ring and pinch, when that happens you get a leak.
Hi Jim, I don't mind doing a few for the folks on this forum so sure I can do some for you. I'm not sure if the '71 VG Valiant has the same tank as a '70 Dart, but I'd expect it is. Especially if it uses the same sending unit. If you'll PM me your address I'll print out a few different...