Parting ways with my Slant. Motor is not assembled but have tons of parts accumulated.
1970 Block overbored 0.060" and o-ringed
1970 head cleaned and mag tested
1970 Crank mag tested and machined 0.010" under
New Billet 90ksi main caps line honed with block
New cam bearings pressed into block...
Hello gents,
For sale, I have my entire, unassembled slant six build. It is incomplete as I was interrupted then started a new project. I'm not looking forward to selling, but I could use the funds.
It contains the following:
-1970 Block. Aftermarket mains. Line bored. 0.060" Overbore...
I decided to go with the slant six, but a single turbo setup. I have not gotten very far with the build, but I have all of the lower end parts gathered.
1970 Forged Crank
Molnar Forged H-Beam rods
Ross Dished Forged Pistons
The cylinders were machined .060 over.
The block has been O-Ringed...
Shipping came out close to 400 from Strange Engineering in Illinois :banghead: but it was worth it. Total came out to 3,400 for a brand new finished rear end with wilwood brakes which is really an unbeatable price for a complete Dana.
The specs:
Strange Super Trak 3.54 Limited Slip
54" wheel to...
I'd like to get a set coming soon. I want my car to be able to roll before I get the engine together. Will it come coated, painted, or bare? If bare then that's fine. I can powdercoat at work. It's unassembled correct? Meaning byshings aren't pressed in either?
I'm trying to get my car to sit nice and low over a 25" tire. I want a good, low, ground hugger stance with a slight rake. I want to hide some fatty cheaters under the back as well. I just want to know if the spindle height is the same as stock or not. I know for sure I wanted a 2" dropped...