I do know I need to get a different throttle cable bracket. This is the one it came with so I made it work for now.
I pulled the intake bolts out and put thread sealant on them, it seems to have slowed down but still seem to get some coming out at higher RPM.
The gob of stuff is a clump of...
It has a new pcv valve.
First intake bolt pulled has no thread sealer on it. Likely found the culprit, will post back once im done and confirmed
Thanks again guys
Thank you.
I should hopefully be able to identify exactly where its coming from if I watch it while it runs? From that thread it sounds like intake bolts or valve covers.
Hey guys, I have a 69 440 HP.
I put an Edelbrock Performer RPM intake on it and I am getting oil coming out the half circle port on the intake side. Why is this? Is this supposed to be blocked off with a special intake gasket?
It seems to be only on the driver side.
I am pretty new to any type...
I have a set of 906 heads that are ported, milled .080, 2.14/1.81 valves in them.
I bought them early this year in here, installed them and ran too big of a cam and intake valves hit the pistons so may need new intake valves. Going a different route and don't need them anymore.
Looking for...
I am looking for an intake such as an Edelbrock Performer, Performer RPM or Mopar Performance M1 Dual Plane intake.
Please message me with what you have and how much you are looking for.
Thanks