No sir, 14x8 with a 215-70 R tire.
too wide.
I am going to replace with the same wheel that is on the front.
Air shocks required to hold up so they dont rub.
USAF, Lt Col, retired, 1972-2000, ND, NH, AL, CO, NM, VA, stateside plus Alaska (2) Germany (2) Bosnia/Kosovo, sent to Shemya instead of Vietnam. Now working for the ANG Readiness Center.
I put one in my new garage. Got it from American Automotive Equipment. 4 poster, has wheels so the lift can be moved around the garage if I want, supposed to be moveable with a car on it. Single hydralic cylindar and heavy steel cables. Was easy to put together, heavy stuff though. Only put...
Chewy
believe so, factory stock on 1964 with slant 6 and 9 inch brakes. Also remembered the front wheels as 14x6, neutral, rear 14x7, deep--I have measured the offset as a good 3 1/2 or 4 inches measured from the front. Am TDY this week so if need to be measured for you will have to wait...
205 /70 14 on the front, 215 / 70 14 on the rear.
front sbp neutral depth, rear deeeeep dish, too deep for me. would like to trade out or buy replacements
I got the carb rebuild kit through local NAPA, only have NAPA and Advance Auto here, Advance had a corresponding number but could not source the supplier or prove what carb the kit was for.
Anyway, new kit in, could not order float thru local stores, but was able to weigh it at NAPA, carb kit...
Dan
Thank you for getting me to the tech articles. Did wonders for knowing what I am looking for.
I reset the float height - not really that far off, and put it all back together and tightened up.
back on the car, ran fine, but the same gasoline dump when the accelerator was pushed...
The Holley 1920 carb on my 64 Barracuda is dumping gasoline out onto the intake manifold. After pulling and cleaning the exterior, there is a small hole or chip on the bottom 'cast tube' running along the bowl on the back side.
It looks like it is actually a drilled hole, but I am just waiting...