Recent content by luvbeer35

PM sent

Cannot send PM your box is full....wondering if still available and if you'll ship?

Sorry not a match but thanks for the pictures.

Is steering wheel in good shape? Color?

Is the oil pan in good shape? Whats the number on the pan? Lookin for one to fit a 63' dart....

There is a port timing hole in the fluid reservoir. The primary seal on the front of the piston in the master cylinder must return past this port when the pedal is released. This will release any pressure in the system due to fluid expansion when the fluid gets hot. It is usually a very small...

I have a 1963 Dart with 9" if that helps.

Welcome!!! 1963 dart GT convert here....

Thanks guys...I didn't notice it. Now I feel like a very great-full idiot.......Your guys are the best. Thanks for the help!

I bought a standard front end kit from PST for a 1963 dart. I pressed the lower shafts into the bushings....No Problem. I went to press the bushing assembly into the lower control arm and it started to buckle and fold......Problem! I measured the other bushing O.D. at 1.466-1.471 seems a little...

I'm looking to replace the 7-1/4 in my 63 dart GT convertible with an 8-3/4 from a 70's dart/demon. Bolt pattern is the same but not sure about the overall length drum to drum, leave spring location, and drive shaft length? Thanks for the help!

Do you still have the arm rests for sale?

What rear end is in the car?

Does anyone know if you can take a cable actuated Holley 1920 from the 70's and swap out the linkage parts so that it can be used on a mechanical system used 63'

What kind of shape is the steering wheel and both front arm rests? cost? Thanks!