I have a 67 barracuda that needed both replaced. I ordered a pair from classic industries, the drivers side was a perfect fit but the passenger side needed a bit of work to fit right but its possible it was only my car. I also remember paying less but that was two years...
I'd say weld it but on a similar completely made of aluminum note, lotus has been essentially bonding there cars together with screws and adhesives for years. What could go wrong?
Hey,
I'm looking for about 1 foot 10 inches total with solid control arm mounts. If possible i need 7 inches forward and backwards of the most outside control arm mounts with roughly 9 inches high from the bottom of the frame for the inside control arm mounts just before the curve under the...
Hey,
Looking for a passenger front frame rail with the control arm mounts for a 67 barracuda. Would have to be shipped to Cambridge Ontario Canada.
Thanks in advance
Dan
That's correct only draw back now that I'm thinking about it is there could be a couple small holes from screwing the pan to the torsion bar frame but otherwise new metal
What measurements do you need and what kind of time line are you working with? I put a full amd pan in my 67 dart and have yet to cut the hump out yet. I have an amd hump already so if those dimensions in the auto will work for you shoot me a pm, I'm located just west of you in Cambridge
Looking to buy a 67 72 A body K member because mine has been butchered, not sure if small block or big block matters but the engine going on it is a 383 so Ill just buy the correct conversion mounts. Im located in Cambridge Ontario so hopefully someone close by or somewhere within a...
i did a full pan on my 67 2 door dart just by sliding it thru the open windows area. i also welded it in with the back window, windshield and dash in just covered everything i didn't want to burn with a welding blanket and it seemed to go very well only draw back was the front where you meet the...
Thanks I went to Napa and actually got everything I needed but the adjustment kit but I was able to use parts I had from other kits so it worked out great.
As far as I know the fronts won't work, on mine anyway they won't the rear end is an 8 3/4 and the shoes on the back are thinner then...
Hey,
Thanks for the replys, i tried midas, partsource and crappy tire and they were all a no go but never thought of napa so i'll give them a call once they open. Yeah maybe i'll have no other choice then to get them re-lined. Oh ok i didn't know that about the fronts thanks for the info...
Hey
I was just wondering what kind of brake shoes everyone was using for there 10 Inch brake drums? I have a 67 Barracuda with SBP all around and 10 inch brakes and i can not find the correct brake shoes or drums without paying the high prices at say yearone for example. There must be...