Recent content by Matt Selwa

What I am not sure of is what bracket style (model year) I need to mount the canister. I have a '72 bracket but it does not appear to be the right one. It would be helpful if I could see what the correct bracket looks like. Matt

Hello, I am in the process of finishing my engine compartment on my '71 225 Slant Six Duster with A/C. Would anyone have pictures of the carbon canister placement - because I do not see where one should be installed in my car since the horn is in the way. I am not sure if it makes a...

Thanks to Moparfan68 I have a cap in good condition. Based on the time to find it I need to make sure I never forget it at a gas station!

PM sent.

I need a gas cap for my 1971 Duster. From what I understand the cap I need was for 1970 California and 1971 for all US A bodies. I am starting to wonder if my only choice will be to pay 100 plus for an NOS one.

Charrlie: Do you know what was changed in the head on hydraulic cam cars? The newer head is wider and uses a different valve cover then the older solid lifter version. -Matt

When I rebuilt my '71 Slant six I decided to convert it over to a hydraulic cam. You will need to do the following: Replace the camshaft with a hydraulic cam. Replace the cam bearings since the rear bearing is different in order to pump the oil to the head. Replace the head with a hydraulic...

I am cleaning out the garage and I have the following parts for sale. I am located north of Grand Rapids, MI. -8.75" Axle Shafts (8 3/4") with small bolt pattern flanges. $100.00 -Power Steering Shaft and Union (to convert your car from manual to power) $40.00 -NOS (almost) set...

I am curious - in the picture of the yard there is a 70's Dart with the Chrysler Road Wheels. Does anyone know if Mopar made a SBP Road Wheel (like the Magnum 500 style wheel with a trim ring). I wouldn't mind picking up a set for my '71 since they would be different. Regards, Matt

Would anyone have the valvetrain in good condition for a 225 Slant Six. The challenge is that I am switching from a solid lifter to hydraulic cam so I need the rocker arms, shaft and pushrods from an '82 - '87 Slant Six (the rockers do not have the adjustment nuts to set the valve lash). I...

HI Eric, Sorry, but I sold my shroud a few weeks ago. Regards, -Matt

Attached are pictures of my slant six shroud for sale. Included is a picture of the P/N and overall size. It came from a '73 or a '74 Scamp with a 225 with A/C. Please note, you should check to confirm if it will fit your radiator since it did not fit my 1972 22" radiator without modifying...

I have the following parts left over from my Duster build in West Michigan. I would prefer to send the parts down the road to someone who will use them instead of scrapping them. -7 1/4 rearend complete from a '73? Duster $40 -904 Transmission from the same car. $40 -22" Slant Six Shroud...

Thanks for the information, that was exactly what I was looking for. I too might have considered a different year manifold had I realized the fun I was in for. But at this point with the manifold blasted, painted and installed in the car + I just spent $30 on a carburator thermostat I am...

The spring is not open to the exhaust. The steel "cup" is installed to plug the hole with a gasket. The thermostat then sits on top of it. However, after 30+ years pretty much everything on mine was rusted out and shot. The thru hole is definitely a factory feature, since I have 2 of them,