Matts440's latest activity
-
Matts440 replied to the thread 67 twin turbo dart.Nope did the same start run for a few seconds and die and one back fire -
Matts440 replied to the thread 67 twin turbo dart.With the bronze gear could it settle lower and not walk like standard gears. Maybe taking a little off the adapter to make it sit more...
-
Matts440 replied to the thread 67 twin turbo dart.Well that victory was short lived. Back to doing the same but now getting these yellow gap marking on composite logger. Wonder if my CPS...
-
-
Hey @TT5.9mag i think I got this whole sensor thing dialed. Max voltage reading would put the AF at 18. Dash is one line short of the...
-
Matts440 replied to the thread Figured id share my garbage...Looking badass as always
-
Not a whole lot of progress. Harnesses are in (photo mock up but they’re in-in now). Figuring out the Holley dash/wide band...
-
Matts440 replied to the thread 67 twin turbo dart.Thanks. It was more of a let's try this sort of thing lol. Funny thing is it ran before this with the poll setting, so not sure what's...
-
Good catch Matt and congrats!
-
Matts440 replied to the thread 67 twin turbo dart.New regulator mounted and the afr's were so much more steady over the mallory on mounted on the rail on the passenger side.
-
-
Matts440 replied to the thread 67 twin turbo dart.Got it to start and run, the secondary ignition timing was on poll setting and switched to raising edge and ran perfect. Such a relieve...
-
Matts440 replied to the thread 67 twin turbo dart.Its just starting, runs for a few seconds then dies. Will need to do a log with trying to start. I didn't think it was the coils, just...
-
Matts440 replied to the thread 67 twin turbo dart.Wonder if a coil is going out??
-
Matts440 replied to the thread 67 twin turbo dart.Well I don't know what to think anymore on this car. Still doing the same thing, even after readjusting all the rockersto cold. Both...
-
-
Matts440 replied to the thread 7875 + 5.9 + E85 + Megasquirt.Oh okay I thought they had both for internal and external balance. PRW makes some good quality stuff.
-
ATI is only for internally balanced cranks. I just found this one. Had to really dig to verify it works on a 5.9 factory crank. Uses the...
