Recent content by maverick

My never-ending project involves a 1964 Barracuda 273, manual, very problematic Kiesler Tremec gig.... it's been a very painful 5 years!:banghead: Could anyone please tell me... is there a cheap starter out there for TTI setup? --preferably less than $329 a pop! I think it's a total rip-off, a...

Couldn't you try to use the "optional" 10.87" HD rotors and some "special" adapters?

Hmm.... I think ideally you would need at least 15" wheels, dude...

What's the difference between the A153 and A153-1? Oh, could you scan and email me the schematic (installation manual)? Thanks!!!

Why not? Here we don't get internet access as much as you guys do back in the states... :roll

Hey there... Did you end up getting the A153? Could you please share the installation schematic of that kit? Coincidentally, I was looking at the same thing... for a 1964 Barracuda. But, could you please tell me, what's the difference between the SSBC A153 and the SSBC A153-1? Here's...

BlownFish, you've pretty much ruined my thread.. THANKS A LOT!!! ....@!#%$^&XZ?><*&^%$!! :munky2: Perhaps, next time you could start YOUR OWN thread under "educational thread"?

Hello everyone, I am looking for 1964/1965 Plymouth Barracuda wood-grain steering wheel in decent/good condition. Please email me if you want to sell yours or if you know of anyone who wants to unload one. Thank you in advance! :cheers:

I am planning to install Dynamat on my 1964 Barracuda. Does anyone here know or have some good/bad review on the product? What's the difference between the regular Dynamat and the Extreme? Is there A LOT of difference? There so many products out there.... and I want the best for my car! --...

I am looking for 10.5 inch flywheel 130 tooth. Please email me if you have one! Thanks.... :cheers:

Hello All: I am "trying" to install a 5-spd TREMEC(Kiesler-Auto) into my 1964 Barracuda. The car was originally a 904/push-button. I got this flywheel from a 65' Formula "S" from Wisconsin which I think has 9.5" diameter. Kiesler-Auto think that they don't have a pressure plate/friction disk...

Hello All: I am "trying" to install a 5-spd TREMEC(Kiesler-Auto) into my 1964 Barracuda. The car was originally a 904/push-button. I got this flywheel from a 65' Formula "S" from Wisconsin which I think has 9.5" diameter. Kiesler-Auto think that they don't have a pressure plate/friction...

Jim: Thanks for your response. I am looking for the schematic to get a close-up info on the side bearing adjustment, details on what gasket I need, etc. I would need to press the bearing on the axle, so I wanted to make sure that I have everything lined up correctly. I have a Shop Manual for...