Recent content by mopartx

Just in case someone is looking for the 340 I have.

I keep some extra mopars in Hot Wheels if you're looking for something in particular.

I have some M2s either mopars and/or chases. I have more Hot Wheels than M2.

I found the chase in that casting.

When 1st built it would do ok if I mixed race fuel with super. There is a gas station close by that I get ethanol free gas from(92 octane). I'm going to try some mixture with it. It just leads to more drive time. Thanks for the input

The next thing I would do is buy some aluminum heads for this engine in my 66 and put the X heads on my 72 dart. I'm about to put my 72 back together and just didn't have the money to spend at this time so it will get a freshened pair of J heads. I had wanted to "stroke the hell out" of 1 to...

I lost my sheet with all the numbers on my 340 build, it was in early 2002. It is probably pretty close, it doesn't like pump gas. When first built it didn't like pump gas much then I blew a head gasket and when I put the heads back on 2 years ago I must have put a thinner head gasket because it...

My 340 has a 360 crank with the 340 pistons milled to clear deck. Old School Storker is what my dad/I wanted to build and he had a lot of parts lying around. I know it's not the cheapest but it does have stock rod/pistons. I apologize if I misunderstood and I am speaking way out in left field.

Thank you. I need to buy something.

I have one also but I'm not much closer. I'm in Texas

Did your crank pulley line up the first time? Is there a timing mark or did you have to put timing tape on it?

On mine I have to put it back together for a car show in a week and then I'll have to take it back apart later to at least paint it. If I have found a solution to my alt gauge problem I will address it then. Until then I'll bolt the leads back together and let it ride. It has been like that for...

Compared to my spare cluster this original cluster looks real clean.

Ok, thanks for info. I'll check my extra alt gauge it there is no way to tighten up the existing gauge. I still haven't seen anything that could be causing my connection problem on the left side of my cluster. I'm going to address the alt gauge first and then repaint the front of the cluster and...