Recent content by Mr Scamp

Wondering if anyone knows if the dd2 style headers from Sanderson will fit my bb 413 going into my Scamp "A" body? thanks!

thanks guys, at this point can't do the weld thing because the stud has been about 80% drilled out, but the bit has "vanished" in there. I may pull the freeze plug to get a better view and see if it's sitting within reach. Sometimes I can't believe how things go, from bad to worse, but hey, it's...

I broke #1 cylinder 906 exhaust stud, while drilling broke the bit :oops:and it's gone inside the water jacket. Any ideas what to do next? Will it theoretically end up in the water pump if it doesn't hang up inside the head? I put a chaser wire in approx. 4.5 " and never bumped it, I figure I...

curious if you still have it? thanks, Mark

I fought mine for ages, checking everything and what it has come down to is a bad match between the cap and rotor. I bend the rotor up a bit and "bam" it fires like new, irritating to the max, but something so simple had me pulling the thing half apart for about a month.

I got a sure grip into my 7.25 no problem, but tried to swap in 323 ring and pinion and just couldn't make it fit by about 1/8 inch, and the mechanic said I needed the old yoke or the pinion would have to be machined? Does this sound right or should he have reset the bearing? Don't know, any...

E3s rock in my book. 5 yr. warranty, see if Auto? will match that! I burned a lot of carbon etc. for a couple hard take offs and now it's clean as a whistle and response is better, heck the plug sits 1/2 inch deeper than my old ones, and yes Slantsix Dan will say these are junk too, but he's...

Is her rearend quiet and smooth? How big is it?