From the schooling i have had for oilfield compressor, i was taught to use deionized water and watch the pH levels to keep the cooling system clean.
If you have access to deionized water it wont leave deposits in your radiator, from what i read it will actually pick up deposits. But if you...
ya nice meeting you, might be doing it again. wish i bought them torsion bars and k from ya. I think it was a V8 k right? or i may just convert this one. thought about maybe getting it straight then weld a piece of plate to it, to put strength back in it. (i tend to over build)lol
Ya almost looks like they where curb jumping it. Trunk pan looks good. 3 quarters need replaced on floor pans. I agree I was suprised about inner fenders my self, only bad spot is where fenders bolted to inner fender, so far.
But after rust removed I think still plenty of metal left.
Here are some pics. The back story on this car is I rescued it out of pasture and pretty much dug it out of the sand. The tires where flat and dragged that way. The rims had flat spots ground on them. Paid 0$ for car but nothing is for free right?
Forward story is I want to build into...
got my engine and transmission out today and noticed the k-frame has alot of big dings in it and front suspension pretty much shot. My question is: Is there any measurements i can make to check the front end to see if i got anything to work with.(to scrap or not to scrap the car) i did not...
not sure if post here or not. No carb. but has 4bbl intake. Have rocked the crank back and forth, but have not rolled all way around. I will sale or trade for 8 3/4 rearend to fit under 74 duster. Located in 73848.