Recent content by OLDSTYLE

  1. O

    Any guide cutter you like?

    Would you not need a .531 seal to go with that cutter?
  2. O

    Red 1968 Barracuda Fastback at the Royal Oak Mi. estate sale.

    Looks like it's got one of those super rare 90deg. carbs
  3. O

    Oil pump question

    (copied from a rebuild posting) Obtain a new 5/8″ deep steel expansion plug Sealed Power 3813052 or similar. Note that the Mopar Performance high-pressure spring kit P3690944 used to include a new plug but no longer does even if the online image shows a plug. The above 5/8 plug is not as deep...
  4. O

    Valve lengths

    SBI lists a stock replacement 1.6 ex. at 5.006 length
  5. O

    340 Help. Am I looking in the right spot to fix the issue

    by the numbers on the cam card should be installed at 107*
  6. O

    [SOLD] Hughes Hydraulic Max Perf. HEH4650B/Lifters/Springs/Retainers for B Engines

    What rockers ?
  7. O

    Distributor bushing removal in car

    Pull the oil pump off and drive it out from the bottom
  8. O

    Balancing a Scat cast crank

    Sure, then you can make money renting it out as a cement mixer.
  9. O

    torquing intake bolts

    Motion Pro Adjustable Torque Wrench Adapters 08-0380 works in hard to get at areas
  10. O

    Valve Cover Bolts Aluminum VC

    1/4 x 20 allen head bolts 3/4 to 1 inch long depending on the thickness of your gasket
  11. O

    More dumb machine tool questions

    For a hobby shop I would look for a 530 or 570 Van Norman rotary broach. Can do heads or blocks
  12. O

    Confirm torq. specs.

    Edelbrock says 25 lbs. I put a dab of silicone on the threads to seal.
  13. O

    Vacuum Pump recommendations

    Motor must be sealed up tight for vac. pump to work right. I usually pressurize motor (5- 10 lbs.) and use a spray bottle with soap and water. Check valve covers, intake valley pan, intake bolts, oil pan, front and rear seals, oil pump mounting, fuel pump plate, timing cover, dist. hole.
  14. O

    Big Block Main Bolt & Oil Pan Bolt Hole Location Blueprint

    The hard part is getting the eight longer main studs needed, 440 source has them at 16.95 ea
  15. O

    Am I an idiot for wanting to boost a high compression 318?

    Boost Compression Ratio Calculator (rbracing-rsr.com)
See more
Back
Top