Recent content by philllyc

I need a 1969 dart radiator 340 manual trans.

Yes, they hit the tires when I spin them and you hear them rubbing the caliper When I remove the tires I see a wear mark on the perimeter of the caliper sides They are old school factory rims, it looks like I might have get modern rims. Any rim suggestions?

I know this is an old thread but I’m having the same problem I replaced all four brakes with Wildwood disk breaks I had to change the axles to Moser for 4 1/2 inch bolt pattern. Now none of my 4 1/2 inch bolt patterns will fit. They rub the caliper you guys have any ideas?

great advice I am having the same issue. I was not sure how to reinstall the new gasket kit until I read your article... Thanks Phil

For sale axles for 8-3/4" rear from a 340 1969 Cuda with new bearings. This is for a 4 inch bolt pattern I replaced my 4-inch with a four and a half I don't need them anymore

Thank you I got the part

I need drivers side motormount bracket for a 69, 340 cuda 4 spd.with ps. I believe it's 2.5 inches wide The block has 3 holes the pictures are of three wrong ones

I didn’t know they were called biscuit mounts thank you!

By the way thanks for the pictures

Looks like I got to use a 318 Mount with a quarter inch of steel laminated via welding on the inside. Do you think that would work?

???? Neither, factory original..

I need a 340 dart drivers side motor mount bracket . Or does somebody have the plans to make one. I have plenty of steel

Thanks in advance

I don't know what I did with them

Originals