I'm already running a 7 1/4 with 1 inch adapters SBP to BBP so even if its the same length im happy at this point. Atleast until I'm ready for a mini tub
What length axles did you use i may have a line on a set for a good price? Where did you get the backing plate and the rest of the internal parts from?
Found this 8 3/4 in my buddy's yard under a trailer frame. I'm gonna pick it up from him tomorrow but I have worries. First of all it's a early pre 65 rear and all though it does have 741 chunk in it it has the tapered axles. I have seen guys a guy swap them to the non tapered axles on...
So I got a complete front suspension off a 68 for the brakes, BBP, and swaybar. I want to put it on my 73 dart that has drums, SBP, and no swaybar. Got the v8 k member with all of the parts. My 73 is a slant 6 with spool mounts and the 68 with biscuits. Can I use the 68 k member when I do my v8...
I am installing a tsp ready to run distributor and e core coil into my 74 scamp and I just want to be sure as to how to jump the ballast resistor. I made a jump wire assuming I needed to connect top post to top post and bottom post to bottom and it would make everything right but I want to be...
FIXED IT!!!!! I had to move that arm it was reading wide open throttle instead so it was essentially waiting till the last possible moment to shift j par thanks for the insight it was exactly as u said