Recent content by R68DartGT

1968 Dart Gt 415 indy cylinder head engine. Based of the 360 magnum.

Thanks for the info.

Hi, I'm looking for information on what backspacing would be recommended for big bolt pattern 15x8 wheel with off set shackles,and largest tire without cutting metal. Thanks.

Only took out 2,4,6,8 plugs.

Bkre611 ngk plugs. 10:1 compression. It's a 415 dual quad indy cylinder head engine.

91 octane gas. I was putting in octane booster but replaced plugs and stopped using the booster for about 4 tanks of fuel.

I plan on running 1:1. Have a single plane intake.

Thank you for the information. It is appreciated. Should the idle mixture screws be a djusted first and then curb idle screws? If so what procedure would you recommend for doing this. Thanks again!!

??

Looking for advice on tuning edelbrock dual quad carbs.Also not sure of the procedure on how to adjust idle mixture screws on dual quad. Balancing, etc. Thanks for any suggestions you can provide.

Thanks

This came out of an indy cylinder head engine and they recommended 93 octane. Problem is in my neck of the woods we only sell 91 octane. It'll spark knock with out it.

Hi, I just took this out after about 100 miles. Looking for opinions on how it looks, rich, lean ,etc. The fuel is 91 octane with lucas octane boost. Appreciate any feedback.

Hi, I have a brand new one that has never been installed and would be willing to sell. If interested let me know.